Mechanical Set Packers


SNAPSET II PACKER

The Snapset II Packer is a compression set tool requiring only straight set down weight to pack-off. This packer is run above another compression set packer (such as the AS-III Packer) to selectively treat, produce or inject in multiple zone completions. This packer is also used to isolate casing hole perforations.

This packer features a large by-pass area to prevent swabbing when running and retrieving. Once the packer is set, pressure from above or below acts down on the valve to maintain the seal and prevent upward movement of the tubing.

When releasing, the valve allows debris to be washed from the upper slips. This packer is equipped with an internal latch to prevent setting prematurely when running in the hole. When releasing, the latch re-engages to allow movement downhole.

Features:

  • Large internal by-pass
  • Set down to pack off, pick up to release
  • Mechanical slips vs. hydraulic buttons
  • Differential pressure holds valve closed

Casing

Recommended Hole Size

IN

Tool OD

IN

Tool ID

IN

Thread Connections

Box Up / Pin Down

Size

IN

Weight

LBS/FT

3-1/2 7.7 - 10.2 2.922 - 3.068 2.781 1.25 1.900 NUE
4-1/2 9.5 - 13.5 3.920 - 4.090 3.750 1.94 2-3/8 EUE
15.1 3.826 3.656 1.94 2-3/8 EUE
18.8 3.640 3.437 1.50 1.900 EUE
5 11.5 - 15.0 4.408 - 4.560 4.125 1.94 2-3/8 EUE
18.0 - 21.0 4.154 - 4.276 4.000 1.94 2-3/8 EUE
5-1/2 14.0 - 20.0 4.778 - 5.012 4.625 2.00 2-3/8 EUE
2.38 2-7/8 EUE
20.0 - 23.0 4.670 - 4.778 4.500 2.00 2-3/8 EUE
2.38 2-7/8 EUE
6-5/8 17.0 - 24.0 5.921 - 6.135 5.750 2.50 2-7/8 EUE
24.0 - 32.0 5.675 - 5.921 5.500 2.50 2-7/8 EUE
7 17.0 - 26.0 6.276 - 6.538 6.000 2.50 2-7/8 EUE
3.00 3-1/2 EUE
26.0 - 32.0 6.094 - 6.276 5.875 2.50 2-7/8 EUE
7-5/8 24.0 - 29.7 6.875 - 7.025 6.672 2.50 2-7/8 EUE
33.7 - 39.0 6.625 - 6.765 6.453 2.50 2-7/8 EUE
9-5/8 32.3 - 43.5 8.755 - 9.001 8.500 3.00 3-1/2 EUE
4.00 4-1/2 EUE
43.5 - 53.5 8.535 - 8.755 8.250 4.00 4-1/2 EUE
 

Work With Us.